DAQ-2024-010144

Utah Division of Air Quality
New Source Review Section Date _______________________ Company ____________________
Form 7 Site/Source
Condensers

Equipment Information

1. Provide diagram of condenser:

2. Manufacturer:_______________________________

Model no.:________________

3. Heat exchange area (ft3):

Contaminant Inlet Conditions

4. Name of contaminant:

5. Pollutant rate:
Inlet: ________________lbs/hr

Outlet: ______________lbs/hr

Average Operation

Maximum Operation

6. Coolant flow rate per condenser:
Water____________gpm or Air_____________scfm

Other: Type____________ Flow rate___________

11. Coolant flow rate per condenser:
Water_____________gpm or Air____________scfm

Other: Type____________ Flow rate____________

7. Gas flow rate: scfm 12. Gas flow rate: scfm
8. Coolant temperature:
Inlet:____________oF
Outlet:___________oF

9. Gas temperature:
Inlet:____________oF
Outlet:___________oF

13. Coolant temperature:
Inlet:____________oF
Outlet:___________oF

14. Gas temperature:
Inlet:____________oF
Outlet:___________oF

10. Efficiency of condenser: %

15. Efficiency of condenser: %

Emissions Calculations (PTE)

16. Calculated emissions for this device
PM10 ____________Lbs/hr____________ Tons/yr PM2.5 ____________Lbs/hr___________ Tons/yr
NOx ____________Lbs/hr____________ Tons/yr SOx _____________Lbs/hr___________ Tons/yr
CO _____________Lbs/hr____________ Tons/yr VOC ____________Lbs/hr____________Tons/yr
HAPs____________Lbs/hr (speciate)____________Tons/yr (speciate)
Submit calculations as an appendix.

Page 1 of 2

Page 2 of 2
NOTE: 1. Submit this form in conjunction with Form 1 and Form 2.

2. Call the Division of Air Quality (DAQ) at [phone] if you have problems or questions in filling out this
form. Ask to speak with a New Source Review engineer. We will be glad to help!

Instructions

1. Supply a diagram showing the features of the equipment.
2. Specify the manufacturer and model number of the equipment.
3. Supply the amount of heat exchange area in cubic feet.
4. List the contaminants found in the gas stream (use additional sheets if necessary).
5. Indicate how much pollutant is in the inlet and outlet gas stream in pounds per hour.
6. Indicate the coolant flow rate per condenser during normal operation. (List the fluid if not water or air)
7. Indicate the gas flow rate in standard cubic feet per minute during normal operation.
8. Supply the inlet and outlet coolant temperatures during normal operation.
9. Supply the inlet and outlet gas stream temperatures during normal operation.
10. Indicate the efficiency of the condenser during normal operation.
11. Indicate the coolant flow rate per condenser during maximum operation. (List the fluid if not water or air)
12. Indicate the gas flow rate in standard cubic feet per minute during maximum operation.
13. Supply the inlet and outlet coolant temperatures during maximum operation.
14. Supply the inlet and outlet gas stream temperatures during maximum operation..
15. Indicate the efficiency of the condenser during maximum operation.
16. Supply calculations for all criteria pollutants and HAPs. Use AP42 or Manufacturers data to complete your
calculations.

f:\aq\engineer\generic\Forms 2010\ form07 Condensers.doc
Revised 12/20/10